Lessons Learned About Services

How To Install a Garage Door The first step to installing a new garage door is removing the old door, using the instructions provided by the door manufacturer, carefully remove the old door, this consists mainly carefully unlatching the door from the pulley system, then the panels of the door are taken apart and then unscrewing the tracks, care should be taken so that the panels do not fall on you by making sure only one panel is removed at a time measurement of the areas where the door is to be installed first takes place, these areas include the door opening height and width, the headroom and the back room, after measurement, to both sides of the opening, stops are attached, they should flush with the inside edge of the door jamb, the bottom piece of the new door is then laid out using sawhorses, additionally weather stripping may be attached, hinges attached and handles lifted to piece setting it properly using a level, the bottom piece is inserted into the door frame, the tap nails then partway into each jamb, to secure them in place the nails are bent slightly then using manufacturer’s instructions, the vertical, horizontal and curved pieces of the track are then assembled and then set aside the second panel is installed on top of the first panel, before installing the hinges, the nails are hammered into the side jambs to make sure they are well held in place, this process is repeated depending on the number of panels, each of the pieces should be anchored into the door jamb, this is the fourth step when installing a new garage door
Lessons Learned About Services
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
The Key Elements of Great Doors
After the vertical tracks are secured against the jambs, the horizontal and curved pieces are then installed, during the installation of the horizontal pieces, you should use the previous measurements, level to make sure that the tracks are straight, and that they are pointing 90 degrees away from the opening, after the tracks are secured, the springs are assembled according to the instructions of the manufacturer, the door is then lifted to about half length so that the tracks are level and parallel, the door is then lifted up the remaining distance and the springs attached to the pulley, basically that is the process of installing a new garage door